Linux release ER 6 - 2012.08 Beta for i.MX6

Note: This image has been taken off-line because it's been superseded.

Please use this tar-ball instead.

Original post

Following up on our previous posts covering our first impressions and our kernel patches, we've just uploaded a filesystem image with the ER6 - 2012.08 release from Freescale's i.MX6.

You can download it from here:

• ER6-1208-Beta.tar.gz

The changes made to the Freescale image are all relatively minor but still worth mentioning:

• We installed our kernel and modules, and
• We added a boot script as discussed in this post., and
• We edited /etc/profile to set LD_LIBRARY_PATH as discussed in this comment, and
• We added firmware for the wl1271 WiFi module into /lib/firmware to allow use of Wi-Fi on the Nitrogen6X, and
• We configured networking for eth0 using DHCP in /etc/rc.d/rc.conf, and
• We removed fslgnome from cfg_services_r in /etc/rc.d/rc.conf/etc/rc.d/init.d/fslgnome doesn't handle the stop command, the reboot process is held up otherwise, and
• We added a password for the root user ("Boundary") so you can log in over SSH.

To use this release, you can create a single-partition SD card using the ext3 filesystem and extract it there: ~/$ sudo tar --strip-components=1 -C /media/boot -zxvf ER6-1208-Beta.tar.gz
The boot script in this image expects to have two things in the bootargs environment variable:

• console - normally console=ttymxc1,115200 to output kernel messages to the serial port.
• video - See this post for details.

Here's how I tested against HDMI: U-Boot> set bootargs console=ttymxc1,115200 U-Boot> set bootargs $bootargs video=mxcfb0:dev=hdmi,1920x1080@60,if=RGB24 U-Boot> saveenv && reset Check out the comments in our earlier post for some of the things supported in this release.