FAQs
Most Recent
- hciconfig -a shows error messages when I use it with the Sona TI351.
- I can’t get the Sona TI351 to come up on a platform that also has an Ezurio 60 Series radio (or vice versa).
- My phone will not connect to the Sona TI351 over Bluetooth but I can get other devices to connect.
- How many clients are supported in AP mode on the Sona TI351?
- Do I need to control the W_DISABLE# signal on the Sona TI351?
- Is Wi-Fi Wake On Wireless supported on the Sona TI351?
- My device hangs when I try to use Bluetooth on the Sona TI351. The radio is connected to a FTDI USB to Serial Interface. Is this a problem?
- What are the Bluetooth UART interface requirements on the Sona TI351?
- I can’t get Bluetooth to start on the Sona TI351
- I’m getting a power on failure with “failed to get sync (-13)” message in dmesg with the Sona TI351
- How do I configure the TI351 to use Out of Band interrupt
- TI351 M.2 1216 solder down module does not enumerate
- What is the correct syntax for using the AT+GCFA command to query for the handle of a characteristic or descriptor in the remote Server's GATT table?
- What is the correct syntax for filtering with the AT+LSCN command?
- How can I tell what peripheral instances are supported in Canvas firmware?
- Can python scripts be loaded onto my device via SWD if no UART is available?
- When building an application with nRF Connect for VS Code, which Board Target should I select for my Ezurio BL54Lxx DVK?
- Does the BL54L15 support LE Audio?
- How can I integrate Ezurios Sona-IF573 PCIe Wi-Fi Module with Raspberry Pi (RPi CM4)
- How can I use Ezurios Sona-TI351 with BeagleBone Black?
- How to set 40MHz in 2.4G band with NX611 in STA mode?
- Will Ezurio provide updated DoCs for RED Cyber?
- How to tell the difference between BL54L15 mass production and engineering sample versions?
- Is it possible to lower the TX Power Level dynamically from the default max TX Power Setting?
Browse through over 1,690 answers by using the search box above or browsing to a specific product.