Can two RM024 radios both set as Client communicate with each other?

Q: Can two RM024-S10 radios both set as Client communicate with each other?   For my application where I would normally have 2 Master radios and 1 Client radio, I am thinking of making the 2 nd Master a Client.  Then I would set the System ID and Channel Number the same on all 3 radios.  My devices have their own address (non-radio related) so if the Client to Client communication could work, this application should work.   A: Yes, it is possible for two RM024 client radios on the same network to communicate with each other. The RM024 is a Server-Client architecture, so there must me one radio configured as a Server in the network , however, the clients can be configured to communicate directly with each other. To configure this there are two options, depending on your desired application. Server:    Auto Config Broadcast Mode Enabled System ID & RF Channel must match on Clients for same network Clients:   Auto Config  Broadcast Mode Enabled , (No Auto Destination/Auto Destination Beacons) Same System ID and RF Channel as Server (This would enable the Clients to communicated with each other and the Server - Data will be sent to all radios on same network.) *****OR***** Server:     Auto Config Broadcast Mode Enabled System ID & RF Channel must match on Clients for same network Clients: Auto Config  Addressed to each other by setting Destination Address to the Destination radio's MAC Address Broadcast Mode  Disabled, (No Auto Destination/Auto Destination Beacons)  Same System ID and RF Channel as Server (With this configuration the clients will only communicate with each other.)